20% Carbon Fiber Reinforced PC
- 20% Carbon Fiber Reinforced Plastic Pellet
- 20% Carbon Fiber Reinforced Thermoplastic For Injection Molding
Carbon fiber reinforced polycarbonate(PC) properties
PC 205A is reinforced carbon fiber reinforced thermoplastic pellet which is a composite material composed of 20% carbon fiber and polycarbonate resin.15% to 30% carbon fiber reinforced pellets are available.
This carbon fiber reinforced thermoplastic has high strength, high elastic coefficient, high impact strength, good fatigue resistance, dimensional stability and small creep (little change even under high temperature conditions).Carbon fiber reinforced polycarbonate(PC) has a wide operating temperature range, the temperature index after reinforcement can reach 120~140℃, and has good aging performance under long-term outdoor use.Solvent resistance shows that carbon fiber reinforced polycarbonate(PC) will not suffer from stress cracking due to solvents.Comparing epoxy resin and metal materials, carbon fiber reinforced thermoplastic features small friction coefficient, good thermal conductivity and heat resistance, and not prone to resonance or chatter. It is an excellent material for shock absorption and noise reduction.
Properties &Data Of Injection Molded Specimens
| Physical property | Standard | Value | Unit |
| Density | ASTM D792 | 1.28 | g/cm³ |
| Shrinkage | ASTM D955 | 0.05~0.2 | % |
| Water Absorption 24hr | ASTM D570 | 0.09 | % |
| Specific Volume |
| 0.781 | cm³/g |
| Mechanical behavior | Standard | Value | Unit |
| Tensile Strength | ASTM D638 | 89 | MPa |
| Elongation Yield | ASTM D638 | 2~3 | % |
| Flexural Strength | ASTM D790 | 157 | MPa |
| Flexural Modulus | ASTM D790 | 8100 | MPa |
| Izod Notch Impact 3.20mm | ASTM D256 | 10.7 | KJ/㎡ |
| Thermal | Standard | Value | Unit |
| HDT 1.80MPa | ASTM D648 | 143 | °C |
| CLE | ASTM D696 | 2.16E-6 |
|
| Electrical properties | Standard | Value | Unit |
| Surface Resistivity |
| 1E3~1E5 | Ω |
| Flammability | Standard | Value | Unit |
| Flame Rating 1~1.5mm | UL94 | HB |
|
| Disclaimer: Data herein is typical and not to be construed as specifications. | |||
Carbon fiber reinforced polycarbonate(PC) application
- Aerospace field
Carbon fiber reinforced polycarbonate(PC) has excellent properties such as light weight, high strength, and high stiffness, so it is widely used in the aerospace field. It can be used to manufacture aircraft fuselages, wings, vertical tails and other components, which can reduce the weight of the aircraft and improve its flight performance and carrying capacity.
- Automotive field
Carbon fiber reinforced polycarbonate(PC) can be used to manufacture automobile parts such as bodies, hoods, seats, etc. Compared with traditional metal materials, carbon fiber has higher strength and lighter mass, which can reduce the weight of the car and improve the fuel economy and driving performance of the car.
- Electronic appliances
Carbon fiber reinforced polycarbonate(PC) is mainly used in electronic and electrical casings, special-shaped materials, mobile phone pressure-holding fixtures, special parts, explosion-proof equipment and other fields.
- Sports equipment field
Carbon fiber reinforced polycarbonate(PC) can be used to manufacture various sports equipment, such as golf clubs, bicycle frames, skis, etc. Carbon fiber has excellent strength and stiffness, which can improve the stability, elasticity and service life of the equipment.
